We have two WLC'2 4402(sw 18.104.22.168) and one WCS with sw 22.214.171.124. I have a lot of client warnings in the controllers trap logs but none clients alarms on my WCS. Is there any reason why the WCS does not reports client problems ?
Use Administration > Logging to access the Administer Logging Options page. This logging function is only related to WCS logging and not syslog information. The logging for controller syslog information can be done on the Controller > Management > Syslog page.
Email Notification can be done with WCS. WCS includes a built-in email notification function that can notify network operators when critical alarms occur. Refer to the WCS Monitor > All Alarms > Email Notification page to view the current alarm notification settings.
From a command drop-down list, choose Email Notification.
Click GO to access this page.
This page allows you to view the alarm categories with the critical-alarm email notification enabled and disabled, the current From and To email addresses, and the current SMTP server. This page also allows you to enable and disable email notification (check box checked = email notification ON; check box unchecked = email notification OFF) for any or all of the alarm categories, and it allows you to access an alarm category email notification setup page.
For every category except Coverage Holes, the alarm severity must be critical to trigger the email. Email notification is available only for alarms, not for events.
Note: If you do not receive emails from WCS, check whether port 25 is blocked.
Note: A WCS administrator currently has no control over which events generate alarms, when they time out, or the degree of their severity. On the controller, individual types of events can be enabled or disabled (such as management, SNMP, trap controls, etc.).
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...