My setup is a Cisco AP 1232 connected to a cisco switch, connected to a cisco router, connected to our DHCP server.
The AP has 2 VLANS and SSIDs, VLAN 1 for Employees and VLAN 2 for Guests. It also has an aditional VLAN for management, VLAN 3.
The APs BVI interface is configured inside the management VLAN.
VLAN 1 requires Radius authentication.
VLAN 2 is a key configured on the client.
When I connect to the SSID for VLAN 2 (guest) I get a good address from the DHCP pool and everything is swell.
When I connect to the SSID for VLAN 1 (employee) I verify it passes the Radius authentication and assoiates. It then times out trying to get a good address via DHCP and comes back with the defualt 169.blah.blah.blah.
Verified all VLANS are allowed to ride all trunks to/from the router.
Process involved in Radius authentication is much longer than the process involved in Configured keys. This might timeout on DHCP request on the clients in Radius Authetication. Try to manually stop and start the DHCP service after successful authentication and se if this works.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...