Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Normal Ethernet Cat5e cable for In-Line Power of Aironet 350 Bridge ???

Anyone please confirm that can I use the normal Cat5e cable for the use of in-line power on Aironet 350 Bridge ?

I was told by my Wireless vendor that I cannot use the normal type of Cat5e cable instead I must the one supplied by Cisco. Is this true and correct ?

Is there any cable length limitation on the Cat5e (other than must less than 100m) ?

Please help out.

2 REPLIES
New Member

Re: Normal Ethernet Cat5e cable for In-Line Power of Aironet 350

It´s not necessary to use a special cable, Cat5 cable is enough.

New Member

Re: Normal Ethernet Cat5e cable for In-Line Power of Aironet 350

It's true. I used a 100 ft homemade cat5 cable to power up my AP350 and it worked fine.

178
Views
0
Helpful
2
Replies
CreatePlease login to create content