Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Not showing Access Point IP address

Hello,

We have several 1200 AP's via dot1q connected, and Cisco PCMCIA adapters. It is possible to see some information of the AP via 'connection status'.

Connection status gives e.g. the Access point Name and ip-address. I dont' want to give this kind of information ( ip-address) to the client. Is it possible on the AP to disable the broadcast of this information.

greetings,

Jeroen

  • Security and Network Management
114
Views
0
Helpful
0
Replies