Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NTP settings on AP 1142N

Hi.

I have a problem with my AP,s , they have the wrong clock time.

My controller (WISM2) have the NTP server set and is works fine. But all the AP (1142N) associated to the controller is not using this NTP server settings, and the clock is running 2 hour wrong.

How can get the NTP settings from the controller to work on all my AP ?

Regards

Johan

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: NTP settings on AP 1142N

AP always show UTC time. R u in UTC-/+2hrs time zone? Then it is no problem.

Sent from Cisco Technical Support iPhone App

4 REPLIES
VIP Purple

Re: NTP settings on AP 1142N

AP always show UTC time. R u in UTC-/+2hrs time zone? Then it is no problem.

Sent from Cisco Technical Support iPhone App

New Member

Re: NTP settings on AP 1142N

Thank you

Then i have to accept this config

Cisco Employee

Re: NTP settings on AP 1142N

I agree with Rasikanayanajith, the behavior you're seeing is due to the WLC's being configured with timezone offset. Since the AP has no way to set its timezone, it will always use UTC.

~BR
Jatin Katyal

**Do rate helpful posts**

~BR Jatin Katyal **Do rate helpful posts**
Cisco Employee

Re: NTP settings on AP 1142N

your welcome:)

~BR
Jatin Katyal

**Do rate helpful posts**

~BR Jatin Katyal **Do rate helpful posts**
210
Views
0
Helpful
4
Replies