I am experiencing this same issue. A debug shows that the GUI seems to be re-sending the credentials for each frame it loads, and then for each click. WHen I log in to the CLI - I have no problems whatsoever and have the appropriate access. Is anyone use SecurID or other OTP for Management of WLCs successfully?
I have had a ServiceRequest open at TAC on this problem and it is now solved. In controller release 22.214.171.124 this works fine and I can now use our SafeWord solution with OTP when we login to the controller.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...