The solution is to use the 'AP-Groups Vlan' feature (assuming you have an LWAPP infrastructure). The feature is also called 'site-specific vlans'. The purpose is to allow creation of a single WLAN and then bind it to multiple dynamic interfaces (i.e. vlans).
The following URL covers the feature and provides a sample configuration:
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...