Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Particular LAP's on WLC 4404 reset to Admin Status = Disable

Hi,

We have around 70 1131's on our 4404 WLC and there are around 5 of them which always seem to reset themselves to Admin Status = Disable.  They are in H-REAP mode as are all the other AP's, but for some reason I have to keep going in and setting the Admin Status of the AP to Enable.  This has been occuring across different firmaware versions since 4, we are currently running 7.

Any pointers or have you experienced this before?

Regards

John

1 REPLY
Hall of Fame Super Silver

Re: Particular LAP's on WLC 4404 reset to Admin Status = Disable

Do you see anything in the wlc logs or even in the switch log? Have you tried swapping AP's around to see if it's the ap or maybe something else? Are these AP's in different locations? Do you happen to know if they move to a different wlc and then back? In the past I have heard of this being an issue but not with newer code.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
528
Views
0
Helpful
1
Replies
CreatePlease to create content