I had a reauthentication problem which was fixed by the hotfix reported on http://support.microsoft.com/?kbid=885453. The hotfix repairs a compatibility issue between MS PEAP and "third party radius servers" (i.e. ACS).
I could successfully login in and out of the XP machine without any network outage since the client is configured to use machine credentials when user credentials are unavailable. Unfortunately, I had a problem with reauthentication, which caused network connectivity to fail after resuming from standby or hibernation.
The patch fixed the problem and added another. Following network login/logout, I lose network connectivity for 60 seconds (configurable via dot1x timeout quiet-period).
Anyone know what is going on and if there is a hotfix to fix the hotfix?
Im about to deploy PEAP and I found also the same problem. What I realized is that is not PEAP what really fails, is MS supplicant the one that fails. I have an Intel PROWireless 2200bg card and I use the Intel PROSet supplicant and no problem has been detected.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...