Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

PEAP authentication on 877W

I am setting up a 877w for home users. Essentially I have 2 Bridge groups, 2 Vlans and 2Wlans. All is working fine until I start on the PEAP configuration. On the switch port if I plug in my laptop it is properly authenicated against on our ISA/Radius. However, the wireless over and over doesn't even talk to the Radius. Can someone point me to a configuration that can help me see my error? I've added my configuration attempt if this helps.

Thank you.

1 REPLY
Gold

Re: PEAP authentication on 877W

I assume you are trying to use the SECURED SSID. If so you need to add the command "authentication open eap eap_methods" under it. Authentication network-eap is used for LEAP and EAP-FAST only.

133
Views
0
Helpful
1
Replies
CreatePlease to create content