I ve been trying to establish PEAP authentication using following configuration :
Windows XP SP1 EAP suplicant (using different client cards - Cisco, 3COM, D-Link), Cisco 1100 AP (12.2(8)JA ) and MS Windows 2000 SP3 IAS radius server with 802.1x fix .
Client setup :
WEP enabled and key is provided for me checked
EAP type - PEAP
PEAP properties - Validate server certifikate checked
Authentic. method - EAP - MSCHAP v2
EAP - MSCHAP properties - Automatically use my Windows logon name and password is unchecked
And I have following problems:
1. After login to Windows, Client authenticates successfully, but no dialog box asking for the client IAS credentials appears.
Checking or unchecking Automatically use my Windows logon name and password in EAP - MSCHAP properties does not seem to have any impact on the login process.
2. If I use the user account that does not meet conditions defined in IAS Server access policies and I try to login, athentication fails and AP stops sending authentication requests to IAS (I use Sniffer to watch the mutual comunication). I have to reset AP in order to make it send new requests to IAS.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...