I am trying to configure a WLC2006 to use PEAP-GTC. The ACS server is currently setup and works find with our autonomous AP's.
In the ACS failed attempts log, I see entries with "PEAP-0012xx4544" as the username instead of the username I enter into the PEAP client on my laptop. I'm using the exact same PEAP client and config on my laptop for both the autonomous and lightweight AP's and I only have this issue with the LAP's. Can someone point me in the right direction?
There was actually an internal Cisco doc that described the fix for this. There were a few timers and such that needed to be changed. I had everything setup correctly and once I changed the timers all was well.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...