Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PEAP help

Trying to make PEAP work. Using FreeRaudis, AP1200 IOS and WinXP clients. Can't get anything working

1 REPLY
New Member

Re: PEAP help

you can check out the following options :

1. On client side enable LEAP.

when u enable LEAP, Data Encryption changes to DYnamic WEP and set Access Point authentication to open.

2.On AP.

Enable accept Authentication type to Network EAP.Also check out the Use of Data Encryption by station to Full Encryption.

Configure Raduis IP address and Port on AP.

you need to configure Shared key also.

TACACs+ use port no. 1645.

3.On Radius server configure AP ip address and Shared Key.

158
Views
0
Helpful
1
Replies
CreatePlease login to create content