Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PEAP on WGB Works, But Time Doesn't Save

I have a WGB that is running PEAP and works fine, but the time doesn't save right. The bridge doesn't work after a reload due to time skew. The clock save interval 8 is setup on the bridge.

AP is a 1252 running 15.2-2-JA1. See attached config.

1 REPLY
New Member

PEAP on WGB Works, But Time Doesn't Save

We've also validated that the device is properly synced to a stratum 3 time source. Is there a bug that's causing this? How do I check for the presence of time on the nvram?

139
Views
0
Helpful
1
Replies
CreatePlease to create content