I'm trying to setup a 871 to authenticate users using PEAP over a site-to-site VPN to an MS IAS server. I setup the IAS according to an MS document. I have the site-to-site up and connected but can't get the client to authenticate. When I check the IAS logs, I show no activity at all. So I suspect a problem with the ACL, but don't really know. My cleaned config is attached below. Any and all help is much appreciated.
I think I follow you when you say the "AP Side", but I've tried that. I applied IPHELPER pointing to the BVI1 interface to both the dot11radio0 and dot11radio0.1. Is there something I need to do to tell the router that I want the BVI1 interface to be the DHCP server?
At this point extranieous broadcasts are fine, I just want to get it working, I figure then I can fine tune it until I break it again.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...