Anybody knows if the Peer to Peer Blocking in WLC can work for inter-WLC traffic? (e.g. WLC-1 and WLC-2 both have SSID1, after p2p blocking action is enabled, can a client under WLC-1 SSID1 communicate with another client under WLC-2 SSID1?)
So if I have SSID1 in 2 WLC, SSID1 in the two WLC is in the same VLAN, I can only use ACL to block local VLAN traffic? If peer to peer blocking only working for intra WLC in the same SSID, seems it's almost useless unless I config different AP groups in different WLC for the same SSID (layer 3 roaming) to make this feature work...
I'm not trying to hijack, but a question popped into my mind. If P2P blocking is only on the local controller, what about for an anchored guest vlan? If the anchor has P2P blocking as well as the anchored controllers, would this cause all of the clients to be blocked from each other at that point?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...