I've seen this tool mentioned only once in the forums, but nowhere in the documentation [that I could find searching via Google and on Cisco site]. And, invoking that command in PI does not help me at all -- e.g., I don't see any of the "red" items to be dragged, much less what basis I would use to drag them to the "correct location".
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...