I have created a map and placed my 3602E APs with AIR-ANT2566P4W-R= antennas. The heatmap prediction is displayed, but I do not believe it is anywhere close to what the actual coverage is. I believe my issue is when you setup an antenna it ask you for azimuth and elevation degrees. These antennas are placed in a 30ft ceiling facing straight down. i have the azimuth set to 90 degrees and the elevation to 90 degrees down. The heatmaps seem much smaller than what the actual coverage is. Did i set the azimuth incorrect? If i'm right it is the only setting that really applies to the way I have my antennas placed.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...