Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PI2.1 : Cannot make Configuration Archive : Fetch Runing/Start Fail

Hello,

I cannot make a configuration archive with PI2.1.

I'm using PI2.1 to control WLC.

When I run Configuration archive, it says Fetch Running: "Unkown error", Fetch Startup "Unknown Error", Fetch VLAN "Unknown Error".

What should be the reason?

 

I can enter in the WLC, configure it from PI, but cannot make "Archive Config"

Please help.

Regards,

1 REPLY
Bronze

Please check the following

Please check the following:

SWIM and Configuration Archives support for Devices during Cisco Prime Infrastructure releases—Table 4 outlines the devices that the software image management and configuration archives support during the various Prime Infrastructure releases.

 

Table 4 SWIM and Configuration Archives support for Devices during Prime Infrastructure Releases

Devices
Prime Infrastructure Releases

Cisco 4400 Wireless LAN Controller1

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco 5500 Series Wireless LAN Controllers

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco WiSM1 Controller

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco 2106 Wireless LAN Controller1

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco 2504 Wireless LAN Controller

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco 2800 and 3800 Series Integrated Services Routers

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco Flex 7500 Series Wireless LAN Controller

1.2, 1.3, 1.4, 2.0, and 2.1

Cisco 8500 Wireless LAN Controller1

1.4, 2.0, and 2.1

Cisco Virtual Wireless LAN Controller1

1.4, 2.0, and 2.1

Cisco WiSM2 Controller

Not supported

1.Prime Infrastructure 1.4 does not support SWIM in Cisco 2106/4400/8500/WiSM2/Virtual WLC.

Hope that helps.

44
Views
5
Helpful
1
Replies