A site survey was done using a 2106 WLC and a 1522 AP. A CB21AG was used as the client card during the survey. Deployment included one 4402 WLC, two 1242AG MAPs, two 1522 Hazardous Location RAPs and nine 1522 Hazardous Location MAPs. The client is attempting to connect to the mesh network with an Xplore Technolgies iX104 tablet with an Intel 2915AG internal wireless card which is CCX ver. 3. The client is experiencing poor quality signal virtually everywhere even with light of sight and being less than 50 meters away from an AP.
What you are more than likely experiencing is multipath fade and distortion. Are you in a piped environment or mining? You might look to upgrade the code on the client device driver or possibly use a cb21 in a card slot if available. The CB21 is a much better card.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...