port-security MAC address restrictions and flexconnect
Hi - has anyone else seen this issue?
We use port-security on flexconnect ports limiting the maximum mac addresses to 100. The ports are configured so that the native vlan is the AP management vlan and we tag the wireless client vlan.
Recently we had an issue where we were seeing MAC address restriction violations on the ports connected to AP's. Although we could not see the violations happen in realtime they were in the switch logs. In Cisco Prime we checked the client counts on the AP's and they were less than 10 at that time the error occurred.
We then increased the max mac addresses to 200 and still saw the same issue. Removing port-security seemed to fix the problem.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...