07-16-2013 11:49 AM - edited 07-04-2021 12:26 AM
Hi all,
My anchor controller is placed after the firewall . Inside zone ISE has been installed. So for any radius communication between ISE and WLC , ports such as 1812 and 1813 should i need to allow ?
Thanks,
TS.
Solved! Go to Solution.
07-16-2013 11:57 AM
Yes they need to be opened on the firewall for radius communication. (UDP 1812- authentication and UDP 1813 - accounting.
~BR
Jatin Katyal
**Do rate helpful posts**
07-16-2013 11:57 AM
Yes they need to be opened on the firewall for radius communication. (UDP 1812- authentication and UDP 1813 - accounting.
~BR
Jatin Katyal
**Do rate helpful posts**
07-16-2013 12:06 PM
Hi Jatin ,
thanks for your reply . We are building the new same setup as below in the doc ,
But it is not mentioned to open the ports of 1812 , 1813 except port number 8443 for web auth.
Kindly confirm on this...
07-16-2013 01:04 PM
Hi Vijay,
I guess you missed it
Look down under the same document page 11, step 11.
~BR
Jatin Katyal
**Do rate helpful posts**
07-16-2013 06:46 PM
yes , i missed it . Thanks Jatin.
07-16-2013 07:17 PM
Your Welcome !!!
~BR
Jatin Katyal
**Do rate helpful posts**
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide