Prime 1.2 AP "Not Associated" alarm not appearing after 1.3 upgrade
We just recently upgraded from Prime 220.127.116.11 to 18.104.22.168 (w/Chrome patch as well).
Before, if we had an AP that lost connection with the controller (was unplugged or other failure), Prime would show an indication of this with a red indicator in the pie chart on the Home page under Inventory Detail Status --> Radios.
After the upgrade to 1.3, AP's losing association to not show an alarm in Prime.
What do I need to do to enable this alarming function again?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...