I have two installations of Prime, virtual appliance 1.3 and physical appliance 2.0. In 1.3, I convert a cad drawing to png and it looks absolutely perfect. When I perform the same task in 2.0, the entire background of the drawing is black. I use the exact same drawing for each install. If anyone has had this happen to them, I would like to hear from them. TIA
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...