Prime Infrastructure 1.3 can not manage third-party switches
I suspect Cisco PI1.3 simply not compatible third-party devices, and even view basic information about third-party switch will not work. Because I have tried to add ZTE S5250 switch, Huawei S9306 switch, RuiJie S5700 switch to PI, but all have failed. Can see the new third-party devices in the Lifecycle template >device work center, but the monitor does not see any third-party information, such as interface, CPU, memory, information, etc., then switch to the classic template, new third party switches are not in config> switchs or unknown device, but in the virtual domain was able to see these devices, these devices can not monitor any basic information. I'm pretty sure the third-party switch SNMP configuration is entirely correct, Ask the experts how to configure the PI to view basic information about these third-party devices ?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...