I have a network with over 50 AP's on one floor. I have let the WiSM blade automatically set the channel and power of each AP. I am finding that the coverage cells are way overlapped and AP's with the same channel are to close to each other.
Would I be better of manually setting both channel and power? What are the pro's and cons of this?
the cons are that it wont be able to fill in for coverage holes if they appear....
RRM only works well when the AP deployment is dense enough. for example RRM wont be able to turn down the power of the ap's unless each ap is heard by 3others at a value of -67 to -70 (depending on the wlc code version)
otherwise they will run at full power which can be too hot.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...