cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
430
Views
0
Helpful
1
Replies

Problem with snmp v3 adding WLCs to WCS

rcullum
Level 1
Level 1

I'm having problems adding 4402 and 2006 WLCs to WCS using snmp v3 credentials. Using auth=MD5 or SHA and Priv=DES. Snmp v1 or v2 works fine, but snmp v3 usually requires 4/5 repeat attempts or rebooting WLC after adding snmp v3 credentials and even then, can take 4/5 attempts. WLCs running 4.0.155.5, WCS is 4.0.81.0.

Anybody seen this before?

1 Reply 1

ethiel
Level 3
Level 3

I saw similar issues, but due to a time crunch gave up and switched to v2 until I could figure it out. I would love to hear any solutions as well.

If I get a chance, maybe I'll try with 4.0.179.8 to see if that makes a difference.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: