Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem with snmp v3 adding WLCs to WCS

I'm having problems adding 4402 and 2006 WLCs to WCS using snmp v3 credentials. Using auth=MD5 or SHA and Priv=DES. Snmp v1 or v2 works fine, but snmp v3 usually requires 4/5 repeat attempts or rebooting WLC after adding snmp v3 credentials and even then, can take 4/5 attempts. WLCs running 4.0.155.5, WCS is 4.0.81.0.

Anybody seen this before?

  • Security and Network Management
1 REPLY
Silver

Re: Problem with snmp v3 adding WLCs to WCS

I saw similar issues, but due to a time crunch gave up and switched to v2 until I could figure it out. I would love to hear any solutions as well.

If I get a chance, maybe I'll try with 4.0.179.8 to see if that makes a difference.

247
Views
0
Helpful
1
Replies