Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem with WCS Client Count

Hi,

I have two wireless clients associated to a WiSM controller, but the WCS shows the client count as all zeros under the "Top 5 APs". However the graph on the right hand side of the "Network Summary" page shows the correct number of associated clients.

See attached screenshot.

Any ideas as to why the number of associated clients reported under 'Top 5 APs' is not correct ?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Problem with WCS Client Count

You will not see those clients because you do not have any APs assigned to maps. Once you create your maps and assign APs to them then the clients will show up in the count. I ran into the same thing. Hope this helps.

3 REPLIES
New Member

Re: Problem with WCS Client Count

You will not see those clients because you do not have any APs assigned to maps. Once you create your maps and assign APs to them then the clients will show up in the count. I ran into the same thing. Hope this helps.

New Member

Re: Problem with WCS Client Count

Thanks for that ssaluga. I don't have maps of the site yet so hopefully when I assign these APs to a map it will fix this.

New Member

Re: Problem with WCS Client Count

I confirm that assigning the AP to a map resolved this issue for me. Thank you.

362
Views
0
Helpful
3
Replies
CreatePlease to create content