Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems converting 1242AP from LWAPP to Autonomous

I tried to downgrade a 1242 LAP to Autonomous through a WLC using cisco's brief instructions:

Step 1 Log into the CLI on the controller to which the access point is associated.

Step 2 Enter this command:

config ap tftp-downgrade tftp-server-ip-address filename access-point-name

Seems easy enough, i copied the IOS file (c1240-k9w7-tar.123-7.JA5.tar) to my TFTP root. Then i ran the command mentioned above from the CLI of the WLC. The WLC takes the command but nothing happens, if i hold down mode and reboot the AP it retains its previous settings? Any ideas?

2 REPLIES

Re: Problems converting 1242AP from LWAPP to Autonomous

Try using the APs full mac address instead of its name and see if that helps you.

New Member

Re: Problems converting 1242AP from LWAPP to Autonomous

In the end i ended up using the a version of the IOS that was one iteration older and it worked......bizzare

213
Views
0
Helpful
2
Replies
CreatePlease to create content