Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question about AP-SSO

Hi everybody:

I have a client who has installed two WLCs in a AP-SSO mode
They have tested the alarms when something critical occur in the active peer, like an interface disconnected
But they are compliant because can't see any alarm if something critical occur in the standby peer

Is this a normal behavior?

This HA system is new for me, but I know the ASA active/standby system and in that case you can monitorize the status of each interface
Are there something similar in AP-SSO?

Do you realize what happen if an interface is down in the standby peer and the active peer fail?

Any comment will be appreciated
Thanks in advance

Al

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Question about AP-SSO

Currently there isn't a way. If you search around the forum, others have also complained about notification and how to monitor the HA pair. Maybe one day is all I can say.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
2 REPLIES
Hall of Fame Super Silver

Re: Question about AP-SSO

Currently there isn't a way. If you search around the forum, others have also complained about notification and how to monitor the HA pair. Maybe one day is all I can say.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Re: Question about AP-SSO

Hi Scot

I'm sorry, I didn't see the other post about this subject

Thank you very much

Al

139
Views
0
Helpful
2
Replies
CreatePlease to create content