Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"AP Memory utilization is Overloaded"

Hi everyone,

I use Cisco AP1131 in a bulding. I have installed and cofigured several AP two months ago.

Yesterday, 2 AP had a fault : "AP Memory utilization is Overloaded (97%)"

I don't undestand why and I can't find the reason which could have lead to this fault...

Have someone been faced with this problem and have managed to solve it?

I read a lot of documentations but it didn't help me...

Thank you for your help!

Khay

2 REPLIES
Blue

Re: "AP Memory utilization is Overloaded"

Fault description and recommended action is explained in the Fault FAQs: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/ts_gd/faults.htm

New Member

Re: "AP Memory utilization is Overloaded"

Hi,

I have already read this page but it didn't help me a lot...

"Verify that the fault threshold is set correctly.

If the threshold is set correctly, review your network to determine the action necessary to clear the fault condition. "

The fault threshold is set correctly...

I have to review now my network but how? which aspects should I look for?

I suspect that the fault results from an attack, like DoS but how could I verify this assumption ?

Thanks U by advance for your help...

209
Views
0
Helpful
2
Replies
CreatePlease to create content