"Logging LWAPP message to 255.255.255.255" after LWAPP Upgrade
I have a WLC 4402 with the AP-Manager IP 192.168.253.34. This WLC is in the version 5.0.148.
I have an AP-1130 with IOS. I upgrade this AP with IOS to LWAPP AP. Just after this upgrade, i see this AP in a state "Download" in the WLC Management page. But after the download, this AP was disassociated.
When i try to restart the AP, i have this log :
Translating "CISCO-LWAPP-CONTROLLER.*****.**"...domain server (*.*.*.*) [OK]
*Mar 1 00:00:31.383: %LWAPP-3-CLIENTEVENTLOG: Performing DNS resolution for CISCO-LWAPP-CONTROLLER.******.**
*Mar 1 00:00:31.383: %LWAPP-3-CLIENTEVENTLOG: Controller address 192.168.253.34 obtained through DNS
*Mar 1 00:00:31.384: %LWAPP-5-CHANGED: LWAPP changed state to DISCOVERY
*Mar 1 00:00:31.856: Logging LWAPP message to 255.255.255.255.
%SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 255.255.255.255 started - CLI initiated
I don't understand why i have this log "Logging LWAPP message to 255.255.255.255" after the LWAPP Discover state.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...