Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Radio Management Assisted Site Survey Error

I get the following error when trying to do a Assisted Site Survey:

ERROR: Measurement request ACK timeout from WDS134.53.52.239/134.53.52.239

This device is managed in WLSE and is available by SNMP. Currently we have all access points including the WDS servers behind a Blue Socket gateway. We have allowed SNMP and port 2887. I suspect we may need to allow another port, however when the WLSE was sniffed during an attempt at the AP scan only 3 SNMP gets FROM the WDS were seen. Any help would be appreciated.

5 REPLIES
New Member

Re: Radio Management Assisted Site Survey Error

Here is the complet AP Radio Scan log:

INFO: Executing the AP Radio Scan

INFO: Max Tx Power 100mW

INFO: Number of devices selected to participate in AP Scanning: 4

INFO: Device HYTAPC110-1.muohio.edu has 1 Radio Interface(s) that can participate in AP Radio Scanning

INFO: Device HYTAPC114-1.muohio.edu has 1 Radio Interface(s) that can participate in AP Radio Scanning

INFO: Device Site_Survey.muohio.edu has 1 Radio Interface(s) that can participate in AP Radio Scanning

INFO: Device HYTAPC305-1.muohio.edu has 1 Radio Interface(s) that can participate in AP Radio Scanning

INFO: Delivering AP Scanning request to Radio Manager, number of Radio Interface(s) = 4

INFO: All interfaces temporarily configured to channel 6

INFO: Radio Scan measurement requests sent to all applicable interfaces

ERROR: Measurement request ACK timeout from WDS134.53.52.239/134.53.52.239

ERROR: Removing interface 00-40-96-45-f9-2e from AP Radio Scan participation

ERROR: Removing interface 00-0a-b7-4c-a5-1e from AP Radio Scan participation

ERROR: Removing interface 00-0c-85-57-3a-5a from AP Radio Scan participation

ERROR: Removing interface 00-40-96-46-28-2c from AP Radio Scan participation

ERROR: No APs are available to particpate - ending AP Scan.

INFO: Temporary channel and power settings disabled

INFO: Radio Scan measurements disabled, returning interfaces to original state

INFO: Radio Scan Complete!

INFO: Completed the execution of AP Scanning task.

Blue

Re: Radio Management Assisted Site Survey Error

Are these g radios?

New Member

Re: Radio Management Assisted Site Survey Error

No, they are 802.11b AP-1210s.

New Member

Re: Radio Management Assisted Site Survey Error

No, they are 802.11b AP-1210s.

New Member

Re: Radio Management Assisted Site Survey Error

It turns out I ran into bug ID CSCec26740. We changed the IP address on the WLSE and forgot to update the WDS. However, the WDS stated the security keys were setup. I'm fairly certain I restarted the WDS AP after the address change and had trouble with it authenticating. Then it just started working, except for the radio measurement features.

160
Views
0
Helpful
5
Replies