Radius Attributes Supported by WLC? Guest bandwidth limiting
I've seen several mentions of limited guest user traffic usage by QoS settings and policy maps.. But my issue with this is, it's a global setting for that SSID. In my case, I have a 'Submit' button our Guest Internet page that does a hidden login of the user Guest. In the past, I would apply a sesion time out of 3hours and limit the bandwidth by quite a bit. However, for vendors and visitors that come in, there was a login section that they could input their uesr/pass given to them by the helpdesk and with radius attributes have an extended time out with greater bandwidth. However, I haven't been able to get this to work on the Controller based service, other then the time-out attribute. Is anyone doing it this way? What attributes does the WLC support?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...