We are trying to deploy RADIUS Based SSID control using Micrsoft 2003 IAS Service. Access Points are running IOS 12.2(13)JA1.
We are trying to return the attribute 1 with "Value" set to
ssid = test
However when a user connects using SSID "test", he is denied access. On the IAS logs i can see that "Access-Accept" was sent to the Access Point, but in Access Point logs i see the "Authentication Failed" message.
If we remove the Attribute from the User Profile, then User can connect fine.
Are we using the in-correct format for the attribute ?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...