Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RADIUS+dynamic VLANs

Hallo!

I have this:

1) 1200 series AP

2) RADIUS server (microsoft IAS)

3) WinXP client for connecting to wirless network

i have already configured my AP to use RADIUS server. Questionis - how i need to configure RADIUS server and WinXP client to dynamically assign vlans to the users, depending on the active directory groups (username and password)?

I have just found, that i need to use IETF 64 attribute, IETF 65 attribute, IETF 81 attribute on he radius server, but what to do next???

Thank you in advance!!

1 REPLY
Cisco Employee

Re: RADIUS+dynamic VLANs

Hi,

You would need to set the attributes to the following value :-

Attribute 64 - VLAN

Attribute 65 - 802

Attribute 81 -

When these attributes are pushed, the AP will put the user in the vlan id specified. The vlan id should already exist on the AP.

Regards,

Vivek

150
Views
0
Helpful
1
Replies
CreatePlease to create content