Radius Server configuration on Windows 2008 Server
I have a customer who has 14 Cisco 1130 Access point on the network. The AP's were authenticating via Windows 2003 Radius server. After there Windows server crashed they have installed new server with Windows 2008 server and tried to setup Radius on that server. Is there any document is there that will show step by step installation on Windows 2008 server and on Cisco 1130 Access point? Any help will that will be grat.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...