Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Rebooting multiple access points with WCS?

What is the best way to reboot multiple access points using WCS? We use WLAN Override to manage SSIDs on our access points, but we need to reboot access points whenever we change the template. Unfortunately, most of the access points are using power injectors, so this isn't easily done from the switch.

4 REPLIES

Re: Rebooting multiple access points with WCS?

Add a template for reboot, and apply it the appropriate AP.

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Community Member

Re: Rebooting multiple access points with WCS?

Thanks! I must have looked past that check box 20 times.

Community Member

Re: Rebooting multiple access points with WCS?

There is not a checkbox option for rebooting in WCS templates for me.  I know it was there at some point, because I've used templates before for just what you're talking about. Any ideas?

Community Member

Re: Rebooting multiple access points with WCS?

WCS - 7.0

555
Views
5
Helpful
4
Replies
CreatePlease to create content