Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Recommended settings and questions about 2500 Controller


Hi,

We are currently deploying a 2500 Controller at a remote site. This will be our first one and our first 802.11n network. First, I noticed that there is no AP manager interface in the controller. This is not used anymore for the APs?

The network we are creating is only going to have 1 VLAN for wired and wireless devices. I didn't create a new interface for the WLAN so I'm assigning it to the MAnagement interface. This is ok, correct?

I noticed that DHCP Proxy is checked by default. Is this going to cause any problems as we are going to be using a Main Campus DHCP server to service the remote site? I added the server address in the WLAN config and the management interface config.

What is scan defer priority, and will having the 4, 5, and 6 checked (the default) cause any problems.

Thank you, Pat.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Recommended settings and questions about 2500 Controller

Correct with the new controllers to do not need to creat an ap-manager interface. The management interface acts as it.

Yes you can use the management I terrace for your clients. As for shop proxy, unless the WLC is going to be a DHCP server go ahead and disable it.

The scan defer is so that if the AP detects those up values it degrees doing an off channel scan. Again. I harm I. Having them enabled.

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1 REPLY

Re: Recommended settings and questions about 2500 Controller

Correct with the new controllers to do not need to creat an ap-manager interface. The management interface acts as it.

Yes you can use the management I terrace for your clients. As for shop proxy, unless the WLC is going to be a DHCP server go ahead and disable it.

The scan defer is so that if the AP detects those up values it degrees doing an off channel scan. Again. I harm I. Having them enabled.

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
213
Views
0
Helpful
1
Replies
CreatePlease login to create content