Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

remote access of laptop get terminated after few second

hello,

we have 5508 wlc, before we were using psk authentication, that time there was no any issue to access remotely any laptops(all are dell laps),now we changed it to 802.1x, now we are getting this problem.

when we try to access any laptops, it gets connected for few second, then after some time remote acces is automatically terminated

plz give me a solution.

wlc5508(7.0.116.0)

2 REPLIES
Hall of Fame Super Silver

Re: remote access of laptop get terminated after few second

Post your show WLAN

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Bronze

remote access of laptop get terminated after few second

By default, the session timeout parameter is configured for 1800 seconds before a authentication occurs.

Change this value to 180 seconds in order to make the client reauthenticate after three minutes.

In order to access the session timeout parameter, click the WLANs menu in the GUI. It displays the list of WLANs configured in the WLC. Click the WLAN to which the client belongs. Go to the Advanced tab and you find Enable Session Timeout parameter. Change the default value to 180, and click Apply for the changes to take effect.

When  sent in an Access-Accept, along with a Termination-Action value of  RADIUS-Request, the Session-Timeout attribute specifies the maximum  number of seconds of service provided before re-authentication. In this  case, the Session-Timeout attribute is used to load the ReAuthPeriod  constant within the Reauthentication Timer state machine of 802.1X.
224
Views
0
Helpful
2
Replies