Reply-Message attribute

[g.peart]

I'm sending various radius attributes to my wireless users connected via 1100 & 1200

the AP forward vlan,SSID,session timeout values

but does not forward the Reply message. A packet capture shows the various attributes being sent by radius server but a debug of AP shows no Reply-Message, is the AP capable of processing this attribute or not and if it can

how do I configure it to do so.

TIA

[g.peart]

Issue solved, it seems that using this attribute is not possible according to RFC 3579

"To avoid these problems, a NAS receiving a Reply-Message attribute

from the RADIUS server SHOULD silently discard the attribute, rather

than attempting to translate it to an EAP Notification Request."