Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restoration of Default settings for 350 Series Access Point

Hello Eric,

I currently have an Cisco Aironet Wireless AP, which was disconnected from a network that no longer exists. When this AP was connected to the network, it was configured with two addresses for ACS Authentication servers. Unfortunately, these addresses were not removed before they were disconnected. Now, when I attempt to reconfigure it offline, I get an Authentication Failure message, also, I can’t configure it online. Is there a way to bypass / restore the default config or reconfigure this AP, since it is no longer possible to connect this to the previous network for Authentication. Thank you for help.

Regards,

Joe B.

1 REPLY
Cisco Employee

Re: Restoration of Default settings for 350 Series Access Point

Here is the url which discuss about "how to get AP back to factory default"..

http://www.cisco.com/warp/public/102/wlan/pwrec-2.html

Tejal

143
Views
0
Helpful
1
Replies