Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

reverting back from wlc 7.6 to 7.4

are there any issues with reverting back from wlc 7.6 to 7.4? I have a 5508 wlc with 2602i access points running flexconnect.

3 REPLIES
VIP Purple

Normally not. I did this many

Normally not. I did this many times.

Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.

Sometime you can see the config difference.  This is because there are configs from the 7.6 that the 7.4 wouldn't understand.

Under normal circumstances, this should be fine.  But there are some cases that this can cause issues. 

 

so keep your config as backup.

 

Regards

Dont forget to rate helpful posts

 

VIP Purple

Normally not. I did this many

Normally not. I did this many times.

Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.

Sometime you can see the config difference.  This is because there are configs from the 7.6 that the 7.4 wouldn't understand.

Under normal circumstances, this should be fine.  But there are some cases that this can cause issues. 

 

so keep your config as backup.

 

Regards

Dont forget to rate helpful posts

 

Community Member

Thank you.I did read the part

Thank you.

I did read the part about a backup config and that makes good sense.

We will be doing that as well.

Thanks again for the verification.

82
Views
10
Helpful
3
Replies
CreatePlease to create content