I am confused, when using Leap does the Wep key get changed each time the client device roams? What kind of time delay does this cause. Does the Access Point give out the new key or do you have to go all the way back to the Radius server to get the new key evertime you roam?
Yes, your key gets changed when you roam to a new AP. The new AP contacts the radius server and authenticates you and negotiates a new key. The process is fast and there is no noticible delay over a regular non-leap roam unless your radius server is very slow. Your key also gets changed on a regular basis if you specify a session timeout value in your radius server (which I highly recommend). This process is seamless also and does not prompt for additional authentication at the client.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...