Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Rogue Policies Configuration

While creating Rogue policies based on SSIDs or RSSI value, should we select "AllAps" for Rogue Location Discovery Protocol ?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

The access points will detect

The access points will detect rogue AP's by default. Enabling RLDP can and will cause issue in your environment if the access point is also serving clients. Please review what RLDP does before enabling that. Typically it would be enabled an access points that are in monitor mode, not set I sing clients. 

Scott

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

The access points will detect

The access points will detect rogue AP's by default. Enabling RLDP can and will cause issue in your environment if the access point is also serving clients. Please review what RLDP does before enabling that. Typically it would be enabled an access points that are in monitor mode, not set I sing clients. 

Scott

-Scott
*** Please rate helpful posts ***
56
Views
0
Helpful
1
Replies
CreatePlease to create content