Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

sample config for a guest access controller outside the DMZ

Greetings,

I have read and have been told that a controller can be used outside the DMZ to facilitate guest access.

I wish to place a 4402 controller outside the DMZ and have it interface with future and existing LWAPP AP's so as to provide guest access on AP's that I choose.

Nobody seems to write about how. Only that it can be done.

Would anyone be willing to share a sanitized configuration for the 4402 so I can get an idea of where to start.

Also have a call in to Cisco, but this might be faster.

Thanks much-

JP

2 REPLIES
Bronze

Re: sample config for a guest access controller outside the DMZ

think I found it!

Bronze

Re: sample config for a guest access controller outside the DMZ

Actually, this doc is much better:

http://www.cisco.com/en/US/netsol/ns656/networking_solutions_design_guidance09186a00808d9330.html

Chapter 10 and a couple of emails and I think I am ready to deploy.

592
Views
0
Helpful
2
Replies
CreatePlease to create content