Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

SAVED PASSWORD AND USER NAME

Hello,

I have a PDA ( windows ce 3.0 formal 11) running CISCO driver 2.30 and firmware 5.20.17 which allow me to have ( when configuring LEAP) saved password and username

This was working correctly until an application has been loaded into the PDA. When i check i have the correct driver and firmware but password and username are not saved definitivly and WLM appears . When i power off the pda i must re-enter password and username. My question is : Do you know where password and username are saved physically ? Do you know if i have to check something else. Many thanks.

Best regards

BEATRICE HOUBAT

MOBILE : 33 (0) 6 08 16 39 10

PHONE : 33 (0) 1 41 97 93 07

FAX : 33 (0) 1 41 97 55 24

2 REPLIES
Bronze

Re: SAVED PASSWORD AND USER NAME

I think the password gets stored in HKEY_LOCAL_MACHINE\Comm\SecurityProviders\SCHANNEL.

New Member

Re: SAVED PASSWORD AND USER NAME

Many thanks.

172
Views
0
Helpful
2
Replies
CreatePlease to create content