I have an RSA SecurID setup which uses a Cisco ACS server with WPA2/PEAP and GTC to authenticate. When I use the Thinkpad Access Connections utility that comes with my laptop I can authenticate to our Cisco 4400 Access controller using my SecurID token.
As I have validated that by back end seutp using a SecurID token is correct I am trying to switch to the Cisco Secure Services Client. How I setup the SSC version 4.1.2 to accept an RSA token? I can get the client to authenticate to our domain successfully but I can't get it to prompt me for a userID and SecurID pin. I also can't find any good documentation on how to set this up - only that it is supported in the 4.1.x client.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...