You can use pretty much any authentication/encryption setup for bridging that you use for clients. So you could use WPA/WPA2/WEP for encryption and PSK or 802.1x for authentication. Really you just configured the SSID the same as if it was for clients. If you decide to use 802.1x for the auth then just configure the local EAP profiles on the bridges.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...